DRL > Bug Reports

[0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances

(1/1)

tehtmi:
I am sad to provide the first 0.9.9.4 bug report, but this is a very minor issue.

The ballistic armor assembly is intended to gives +30% to melee resistance, but instead it sets it to 0%. It is intended to set acid resistance to 0%, but it doesn't change acid resistance.

ParaSait:
Heh. Funny how this is discovered right after the 0994 release, even though it's been beta tested for long.

tehtmi:
Well, this is something that is hard to notice without looking at the sources... which I just did again when I was adding the new assemblies to the wiki... which I had waited for the public release to do. :(

Navigation

[0] Message Index