Chaosforge Forum

DoomRL => Bug Reports => Topic started by: Tavana on December 16, 2009, 13:59

Title: Chainfire cannot target...
Post by: Tavana on December 16, 2009, 13:59
Playing Ao100, dlevel24, Ammochain build + going for brute/berserker just in case I find a DS.

The following happened when chainfiring my Plasmarifle A3P1:

Code: [Select]
#.####
#....2
#@...#
1....#
#....#

I fired and killed a monster in position 1 (a doorway, if that matters). Chainfire autotargetted the monster in position 2(also a doorway!), and I hit f to fire again.

As the barrel swiveled around, the shots not lost to the turn landed somewhere around here:

Code: [Select]
#.##X#
#....2
#@...X
%....#
#....#

I fired again, and received a lot of "Boom!", my shots seeming to alternate between the two points. Thankfully, after my third volley, a monster appeared in the top doorway, so I switched target to him, and chainfire successfully autotargetted monster #2 this time around.
Title: Re: Chainfire cannot target...
Post by: Tavana on December 16, 2009, 14:01
Sorry, I should have noted: this is the 9.9.1 Beta. I'm uncertain if it's beta specific, though.
Title: Re: Chainfire cannot target...
Post by: Malek Deneith on December 23, 2009, 13:30
Posted to the tracker.