Chaosforge Forum

DoomRL => Bug Reports => Topic started by: tehtmi on September 01, 2011, 09:38

Title: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
Post by: tehtmi on September 01, 2011, 09:38

I am sad to provide the first 0.9.9.4 bug report, but this is a very minor issue.

The ballistic armor assembly is intended to gives +30% to melee resistance, but instead it sets it to 0%. It is intended to set acid resistance to 0%, but it doesn't change acid resistance.

Title: Re: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
Post by: ParaSait on September 01, 2011, 09:46

Heh. Funny how this is discovered right after the 0994 release, even though it's been beta tested for long.

Title: Re: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
Post by: tehtmi on September 01, 2011, 10:08

Well, this is something that is hard to notice without looking at the sources... which I just did again when I was adding the new assemblies to the wiki... which I had waited for the public release to do. :(