Chaosforge Forum

  • October 31, 2024, 17:06
  • Welcome, Guest
Please login or register.



Login with username, password and session length
Pages: [1]

Author Topic: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances  (Read 1987 times)

tehtmi

  • Programmer
  • Local Inquisitor
  • Lieutenant Colonel
  • *
  • *
  • Offline Offline
  • Posts: 458
    • View Profile
[0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
« on: September 01, 2011, 09:38 »
I am sad to provide the first 0.9.9.4 bug report, but this is a very minor issue.

The ballistic armor assembly is intended to gives +30% to melee resistance, but instead it sets it to 0%. It is intended to set acid resistance to 0%, but it doesn't change acid resistance.
Logged

ParaSait

  • Baffen :P
  • Elder
  • Lieutenant General
  • *
  • *
  • Offline Offline
  • Posts: 1229
  • Happy Little Boozer
    • View Profile
    • MPSF
Re: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
« Reply #1 on: September 01, 2011, 09:46 »
Heh. Funny how this is discovered right after the 0994 release, even though it's been beta tested for long.
Logged
[18|7|3|0|0|0] [MED:13/43] [SPE:36/67] [ASM:11/40]

Check out my epic youtube channel!
Currently playing The Bard's Tale and System Shock 2 (coop with GrAV1t)!

tehtmi

  • Programmer
  • Local Inquisitor
  • Lieutenant Colonel
  • *
  • *
  • Offline Offline
  • Posts: 458
    • View Profile
Re: [0.9.9.4] Ballistic armor assembly doesn't quite have the intended resistances
« Reply #2 on: September 01, 2011, 10:08 »
Well, this is something that is hard to notice without looking at the sources... which I just did again when I was adding the new assemblies to the wiki... which I had waited for the public release to do. :(
Logged
Pages: [1]